REG-корпус 4 TE
Модуль расширения для аналогового актуатора на 4 канала арт.: 2204.01 REGA
Функция
Connectable analogue actuators
Модуль расширения для аналогового актуатора на 4 канала арт.: 2204.01 REGA
Функция
- The analogue actuator module extends a KNX analogue actuator 4-gang by four additional sensor outputs, which can be parameterised by software.
- Received data are converted into the output signals 0 ... 1 V, 0 ... 10 V, 0 ... 20 mA, or 4 ... 20 mA
- The analogue output signals enable heating, ventilation and air conditioning units to adapt their output values to information received from the bus and thus to take part in control processes.
- The output variables can be forced.
- The evaluation of the module data itself and the processing of the forced operation takes place in the KNX analog output.
- The analogue output module is connected to the KNX device via a system plug included in the scope of delivery.
- Outputs that are not required can be switched off.
- Voltage outputs are monitored for short circuits.
- The output state is indicated by status LEDs.
Connectable analogue actuators
- Do not connect electronic ballasts or electronic transformers with 1-10 V control input to the outputs.
- Do not connect external voltages to the outputs. All connected components must ensure safe separation from other voltages.
- Current outputs may be loaded with 500 ? max.
- Voltage outputs must be loaded with 1 k? min.
- The GND terminals of the outputs K1 ... K4 are connected internally.
- In the event of a short-circuit between a voltage output K1 ... K4 and GND, the respective output is deactivated.
- около 155 г
- -5 ... +45 °C
- -25 ... +70 °C
- 72 мм (4 установочных модулей)
- 1 x 0.5 ... 4 мм²
- 1 x 0.5 ... 4 мм²
- 1 x 0.5 ... 2.5 мм²
- макс. 120 мA
- макс. 93 % относительной влажности. без конденсата
- 4
- 0 ... 1 B DC. 0 ... 10 B DC.0 ... 20 мA DC. 4 ... 20 мA. DC
- screw terminals
- ≥ 1 kW
- ≤ 500 Вт
- 6 мA
- system connector. 6-pole
Пока нет комментариев
Написать комментарий