Сенсор температуры, WS 10 T
Артикул: WS10T
Есть на складе
напряжение питания: 24 В DC
диапазон измерения: –30 °С - +70 °С, линейная характеристика
The brightness sensor is used for the measuring and evaluation of the brightness.
The dawn sensor is used for the measuring and evaluation of the brightness (dawn/dusk).
The temperature sensor is used for the measuring and evaluation of the temperature.
The value measured by the sensor is transmitted to an analogue output signal of 0 ... 10 V by the electronics.
Connections:
Plastic housing with PG7 thread + screw and pressure / moisture compensation (recommended cable 3 x 0.25 mm2)
+UB: operating voltage 24 V DC
GND: corresponding ground
OUT: output 0 ... 10 V
диапазон измерения: –30 °С - +70 °С, линейная характеристика
The brightness sensor is used for the measuring and evaluation of the brightness.
The dawn sensor is used for the measuring and evaluation of the brightness (dawn/dusk).
The temperature sensor is used for the measuring and evaluation of the temperature.
The value measured by the sensor is transmitted to an analogue output signal of 0 ... 10 V by the electronics.
Connections:
Plastic housing with PG7 thread + screw and pressure / moisture compensation (recommended cable 3 x 0.25 mm2)
+UB: operating voltage 24 V DC
GND: corresponding ground
OUT: output 0 ... 10 V
- screw terminals
- 0 ... 10 V DC (into a load of at least 1 kΩ. short-circuit protected)
- макс. 100 м
- -30 ... +70 °C
- IP 65
- 58 x 35 x 64 мм
- 2.5 мм²
- through screwed conduit entry PG 7
- optional
- 3 x 0.25 мм²
Пока нет комментариев